Maintenance and maintenance of chain saw (2)

Maintenance of starting device 

1. Change when starting rope or starting spring, the first thing to release starting spring pre-tightening force.
2. Be careful when remove starting line from the start of spring, prevent spring scatter pop-up cuts.
3. After the change, will be starting spring and starting wheel axle hole before assembly place daub grease, assembled again.

Maintenance of saw chain guide 

1.The file after the saw chain wear, and repair the file when in the right direction, and should be paid attention to about the Angle of the tooth, avoid running deviation when sawing;Ensure the set limit to the height of the tooth is consistent, so as not to beat.
2.Guide work after a period of time to also want to maintain and repair the file.
3.Check wheel rotation is flexible;Timing for roller bearing with grease, each add a fuel must give at the same timeRoller bearing is filling the complex lithium grease;Check the guide oil hole blockage, dredge and cleaning in a timely manner.
4. The guide is often used in surface, in order to make sure on both sides of the guide plate wear synchronization to extend the service life;"In" flash" groove guide timely repair the file.

click here to get more information : www.bakparts.com