Pants
Special Textile has developed a chainsaw clothing, and this development is still very active.Traditionalfabric to protect against chainsaw running useless, was immediately cut through.
There are the fabric that the use of a more severe impact and make a real fight of light, flexible and comfortable enough for the user between. This allows the user hot clothes, or to prevent the user can easily move, is in itself a security issue. A worker suffering heat stroke is not safe. Additional fabric layers can be added to the laundry to improve the cut resistance, but the clothes can not be made a powerful saw in all cutting it is impractical, even with modern fibers. Worse, saws, chain technology seems to exceed the fabric technology. High power saws and chain slashed almost impossible to prevent.
Classification scheme has been developed EU rate pants, the fabric in general, protection against cutting.
Chainsaw chain speed manual provisions. A higher level of pants are more expensive, hotter and heavier, so there is an advantage to choose pants that match the saw.
There are two standard types of trousers, A-type and C-type .A type protects only the front of the leg, and can be provided as chapped, wearing the traditional clothes, or as a traditional trousers. C-protected full-leg, almost all dressed in
ordinary trousers, no end other clothes. CHAPS generally used for occasional farm or homeowner's application. Professional chainsaw operator will choose the comfort and ease of movement trousers and losers, ground staff and firewood tool selection,because the back was cut low-risk category
A long trouser legs. Tree climbers and doctors would have to wear a C-type, because they will be cutting from a wider
variety of positions. C-type trousers, of course, highly
insulating, if wearing labor-intensive operations, such as
cutting wood may cause heat stress. In some of the principles chainsaw protective fabric works. The outermost layer may be formed both tough and slippery, to prevent damage could jeopardize filler negligible. Under this long, polyester, aramid ballistic nylon or loose laid in layers. When contacting a saw pants, the outer layer is cut off immediately by, but inside is pulled out and wrapped around the saw drive sprocket, chain suspended solids and lock it to restrict the operator's leg injuries. Pants should be slightly loose, so it was given, instead of pulling the leg into the chain saw, but stopped to pull excess fabric into a chain mechanism. After stopping the saw, pants scrapped, and saw the ground must be stripped to remove fibers, and allow it to run again.
To be continued...
没有评论:
发表评论