BakParts: Hammer Introduction (c)

2016年6月19日星期日

Hammer Introduction (c)

Personal protection when using the hammer

1, the operator must wear protective glasses to protect the eyes, face upward when the job is to wear protective masks.
2, long-term job fortress good earplugs to reduce the impact of noise.
3, long after the job is in the drill burning state, should pay attention to the replacement skin burns.
4, the job should use the side handle, two-handed operation, to prevent the reaction sprained arm when stall.
5, standing on a ladder or work should be prepared to work at heights falls measures ladder should be ground personnel support.
Second, it should be careful before operation
1, confirm the site connected power supply and hammer plate match. It is connected with leakage protection.
2, with the drill bit holder should be adapted and properly installed.
3, drilling walls, ceiling, floor time, you should first confirm whether the laying of cables or pipelines.
4, in the high places, to give full attention to the following objects and pedestrian safety, set up warning signs if necessary.
5, confirm the hammer switch is off, if the power switch is turned on, then plug into an electrical outlet power tool will start turning immediately, which could lead to personal injury hazards.
6, When the work area away from the power source, the need to extend the cable, use sufficient capacity, the installation of qualified extension cable. Extension cord, such as by a pedestrian should do or overhead cables laminated Measures to prevent damage.

For more power tool please click here for reference.